Whitehouse BEEHIVE BK-HPDH30, Instruction Manual

Page: 3 / 4

The Base Back Riser
should sit flush with the
back edge of the base
board.
Marking Lines
Place the Base Board down on your workspace. See Diagram 1
to identify where you need to use your pencil to mark where the
cleats will be placed.
Note: The side which is facing upwards to you will form the
outside base of your beehive.
Placing Cleats
Place the edge of your 2x Cleats within the 14 cm pencil mark as
shown in Diagram 2.
Once done, put cleats in place and turn it over.
Diagram 1
Diagram 2
Nailing Cleats
Use
4x 30mm
nails to attach the
Cleats
to the
Base Board.
Note: We suggest placing the nail 10cm in from the edge of the
Cleats on each side. Once done put the assembled baseboard &
cleats to the side for later.
Diagram 3
Nailing Base Board Riser
Gather the base board part
No. 3, 4, 5 & 4x 25mm nails.
Place and nail the corners as shown in Diagram 5.
30mm
Diagram 5
Diagram 6
3
Aligning to Base Board
Place your assembled Base Board Risers on your assembled Base Board as shown in
Diagram 6. Use your 8x 25mm nails to attach Base Board Risers to Base Board.
1
2
25mm
4
5
25mm
1
2
1
2
14cm
14cm
14cm
14cm
10cm
The Base Entrance Riser should be at least
2.5cm away from the front edge of the base
board. See Diagram 6.
If unclear, view this manual’s cover to see
complete assembled beehive. You will
notice some space between the Entrance
Riser & Base Board edge.
IMPORTANT
2.5cm