18
Locating the Filter
Your refrigerator is equipped with a water
filtering system. The water filter system filters
all dispensed drinking water, as well as the
water used to produce ice.
Water Filter
The water filter is located at the top right side
of the fresh food compartment.
Ordering Replacement Filters
To order your replacement filters, please
contact manufacturer.
Here are the product numbers to request when
ordering:
PureSource 3
TM
Water Filter
Part #
WF3CB
Replacing the Water Filter
In general, you should change the water
filter every six months to ensure the highest
possible water quality.
Water
Filter Status
on the user interface prompts you to replace
the filter after a standard amount of water
(200 gallons/757 liters for
PureSource 3
TM
)
has flowed through the system.
If your refrigerator has not been used for a
period of time (during moving for example),
change the filter before reinstalling the
refrigerator.
Filter Cartridge
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system. Systems
certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
Test & certification results:
• Rated Capacity - 200 gallons/757 liters for
PureSource 3
TM
ice and water filter
•
Rated service flow - .50 gallons per minute
• Operating Temp.: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds per
square inch
• Recommended Minimum Operating
Pressure: 30 pounds per square inch
To replace your PureSource 3
TM
water
filter:
It is not necessary to turn the water supply off
to change the filter. Be ready to wipe up any
small amounts of water released during the
filter replacement.
1 Turn Off the ice maker.
2 Remove the filter by pushing on the end/
face of the filter.
3 Slide the old water filter cartridge straight
out of the housing and discard it.
4 Unpackage the new filter cartridge. Using
the alignment guide, slide it gently into the
filter housing until it stops against the snap-
in connector at the back of the housing.
5 Push firmly until the cartridge snaps into
place (you should hear a click as the
cartridge engages the snap-in connector).
6 Press a drinking glass against the water
dispenser while checking for any leaks at
the filter housing. Any spurts and sputters
that occur as the system purges air out of
the dispenser system are normal.
7 After filling one glass of water, continue
flushing the system for about four minutes.
8 Turn On the ice maker.
9 Press and hold the Water Filter button on the
Ice & Water Dispenser control panel for three
seconds. When the display changes from
“Red” to “Green,” the status has been reset.
The PureSource 3
TM
ice and water
filter system is tested and certified
to NSF/ANSI Standards 42 and 53
for the reduction of claims specified
on the performance data sheet.
More about your Advanced
Water Filter
CHANGING THE FILTER
