background image

7

Car

Car

Car

Car

Care and Cleaning

e and Cleaning

e and Cleaning

e and Cleaning

e and Cleaning

Inside

Remove items from the washer as soon as the cycle ends. Excess wrinkling, color
transfer, and odors may develop in items left in the washer.

Dry the washer top, the area around the lid opening, and the underside of the
lid. These areas should always be dry before the lid is closed.

Before cleaning the washer interior, 

unplug the electrical power cord

 to avoid

electrical shock hazards.

When extremely soiled items have been washed, a dirty residue may remain on
the tub. Remove this by wiping the tub with a nonabrasive household cleanser.
Rinse thoroughly with water.

The agitator or tub may become stained from fabric dye. Clean these parts with
a nonabrasive household cleanser. This prevents dye transfer to future loads.

Outside

When washing is completed, wipe top and sides of washer with a damp cloth.

Turn water faucets off to prevent pressure build-up in the hoses.

As needed, clean the cabinet with mild soap and water. 

Never use harsh, gritty

or abrasive cleansers.

 If top or lid becomes stained, clean with diluted chlorine

bleach [1/2 cup (120 ml) in 1 quart (.95 L) water]. Rinse several times with clear
water.

Remove glue residue from tape or labels with a mixture of warm water and mild

detergent. Or, touch residue with the sticky side of the tape or label.

Before moving the washer,

 place a strip of cardboard or thin fiberboard under

the front leveling legs to prevent floor damage.

Winterizing Instructions

If the washer is stored in an area where freezing can occur or moved in freezing
temperatures, follow these winterizing instructions to prevent damage to the washer:

1.

Turn off water supply faucets.

2.

Disconnect hoses from water supply and drain water from hoses.

3.

Plug electrical cord into a properly grounded electrical outlet.

4.

Add 1 gallon nontoxic recreational vehicle (RV) antifreeze to empty wash tub.
Close lid.

5.

Set cycle selector knob at a spin setting. Pull out knob and let washer spin for
1 minute to drain out all water. Not all of the RV antifreeze will be expelled.

6.

Push in knob, unplug electrical power cord, dry tub interior, and close lid.

7.

Store washer in an upright position.

8.

To remove antifreeze from washer after storage, run empty washer through a
complete cycle using detergent. 

 Do not add wash load.

 Use care with laundry

products. They can damage finish on
the washer.

Follow Winterizing
Instructions for cold
weather care.

Summary of Contents for SWS1233CQ










Reviews: