Cutting Deck Removal
1MBDFUIF150#MBEF&OHBHFLOPCJOUIFEJTFOHBHFE 0''
1.
position and engage the parking brake.
Lower the deck by moving the deck lift lever into the
2.
bottom notch on the right fender.
-PDBUFUIFFOHJOFQVMMFZ PSFMFDUSJD150DMVUDIJG
3.
FRVJQQFEVOEFSUIFGSPOUPGZPVSUSBDUPS4FF'JH
3FNPWFUIFCFMUHVBSEBOECFMUBTGPMMPXT3FGFSUP'JH
Remove the hex screws.
a.
1VMMUIFCFMULFFQFSSPEUPUIFSJHIUBOEEPXOUP
b.
remove.
3FNPWFUIFEFDLCFMUGSPNBSPVOEUIFUSBDUPST
c.
FOHJOFQVMMFZ PSFMFDUSJD150DMVUDIJGFRVJQQFE
NOTE:
If there is too much tension on the belt for it to be easily
SFNPWFEGSPNUIFFMFDUSJD150DMVUDIDBSFGVMMZJOTFSUB
3⁄8” drive
ratchet wrench (set to
loosen
) into the square hole found in the
EFDLJEMFSCSBDLFUBOEQJWPUJUUPXBSEUIFUSBDUPSTMFGUTJEFUP
SFMJFWFUFOTJPOPOUIFCFMU4FF'JH
8"3/*/(
"WPJEQJODIJOHJOKVSJFT/FWFSQMBDF
your fingers on the idler spring or between the belt
and a pulley while removing the belt.
Looking at the cutting deck from the left side of the tractor,
5.
locate the deck support pin on the rear left side of the
deck.
1VMMUIFEFDLTVQQPSUQJOPVUXBSEUPSFMFBTFUIFEFDLGSPN
6.
UIFEFDLMJGUBSN4FF'JH
3FQFBUUIFBCPWFTUFQTPOUIFUSBDUPSTSJHIUTJEF
Move the deck lift lever into the top notch to raise the deck
8.
lift arms up and out of the way.
'JHVSF
%FDL*EMFS
#SBDLFU
'JHVSF
%FDL-JGU
"SN
%FDL4VQQPSU
Pin
'JHVSF
Service
7
