4
―
ELECTRICITY SUPPLY INDICATOR
, marked with the symbol
When the appliance is
connected to the electricity supply, the green indicator light is illuminated. Simultaneously also the
the temperature rise indicator
lights up
. It indicates that the freezer was switched off for a
longer time, i.e. the freezer is switched on for the first time, after defrosting or after losing
of
voltage.
When the temperature in the compartment again falls below -9 ºC, the indicator light will
go out.
6
―
THE TEMPERATURE RISE INDICATOR
is marked with the symbol
When the temperature
in the freezer compartment rises above -14 ºC, the red indicator light is illuminated.
It indicates that:
•
The freezer was switched off for a longer time, i.e. the freezer is switched on for the first time,
after defrosting or after losing of voltage.
•
The door of the freezer is opened or is being opened too frequently.
•
It is loaded a large amount of unfrozen foodstuffs.
•
The freezing system is failed, i.e. the indicator does not go out longer 6 hours and it
is heard running compressor or the compressor does not switch on. In this case you
should apply to your service agent (at first make sure that three above items were
taken into account).
CHANGING THE OPENING DIRECTION OF THE DOORS (fig.6)
It is recommended that changing the opening direction of the doors should be done with a helper.
You will need two spanners No. 8 and No. 10 and a Philips head screwdriver.
!
When changing the opening direction of the doors, YOU CAN NOT lay the refrigerator horizontally.
Do the actions below in the order they are
listed:
WARNING! Turn off the appliance and
pull the plug out of the electricity supply
socket.
1.
Remove bottom bracket
1
. Remove bottom
bracket
2
together with the washers on
the axle and the plastic spacer. Remove
compartment door.
2.
Remove cap
4
from the refrigerator door
and press it in on the opposite side.
3.
Unscrew axle
5
by turning it counter-
clockwise. Remove it together with the bolt
and washers.
4.
On the opposite side, screw in axle
5
in a
clockwise direction together with the bolt
and washers.
5.
Turn bracket
2
, together with the nuts on
the axle and the plastic spacer, around a
full 180°, replacing the nuts on the axle
and tightening them on the opposite side.
6.
Screw bottom bracket
4
together with the
washers on the axle and the plastic spacer
into the place for bracket
2
. Screw bracket
2
into the place for bracket
4
. Remove bolt
caps (
a
) and plugs (
b
). Unscrew the bolts
holding the handles in place. Move the
handles to the other side. Screw on.
Press plugs into the remaining apertures in
the door and cover bolts with caps
a
.
7.
Replace bottom lid
1
.
