INSTALLATION
The tumble dryer is fully compatible with any 600mm deep kitchen units and complies with stringent EEC
regulations.
Your dryer is provided with a vent hose which will extend to approx 2.4m (8ft). We strongly recommend that this
is vented through the wall with the attachment provided. The position of the hole (100mm diameter) for the vent
directly behind the tumble dryer is shown in the diagram.
If the through the wall vent is to be positioned other than behind the dryer, the vent hose should be positioned at
floor level and through adjacent side panel to a relevant position. The plinth must be cut-out to accommodate the
air vent grill at the bottom front of the tumble dryer.
IMPORTANT
The air vent at the front of the appliance must never be covered or blocked in any way as this will cause the dryer
to overheat.
This appliance must not be installed behind a lockable door, a sliding door or a door with hinges on the opposite
side to that of the tumble dryer.
The dryer should not be placed directly next to ovens or cookers, as the performance of the dryer may be affected.
ELECTRICAL CONNECTIONS: We strongly recommend that any electrical work is carried out by a qualified
person complying with the IEE 17
th
addition of the electrical regulations.
IMPORTANT
Please remember that the tumble dryer must be capable of being switched off, (disconnected from the supply),
when fitted in position
