CLEANING THE FILTER
ALWAYS CLEAN THE FILTERS AFTER EACH USE
. Failure to do so could cause the
safety cut-out to operate.
EMPTYING THE WATER BOTTLE
To clean the filter located in the door, slide the filter
upwards and away from the appliance.
Remove any threads or fluff from the filter by hand
or with a soft brush.
Remove any fluff inside the filter housing.
Ensure that the filter is the right way round and slide
back into the door.
–
Pull the bottle out from the dryer and empty at the end of
the drying cycle.
–
WARNING:
Ensure that the bottle is kept level and the
rear supported as it is removed from the dryer in order to
prevent water leaking from the water in-feed hole at the
rear of the bottle.
–
Replace the bottle ensuring that it is pushed all the way
in.
–
If the dryer is connected to a drain there is no need to
empty the bottle but it must be correctly fitted to the
machine.
–
WARNING:
Empty the water container after each use.
The drying cycle will pause and the
icon light if the
bottle is full during the drying process. After the bottle
has been emptied, the dryer can be restarted by pressing
the Start/Pause button.
–
WARNING:
Do not drink the condensed water
To remove the filter in the door opening, lift out the filter using the slots at either end.
Remove any threads or fluff from the filter by hand or with a soft brush.
Refit the cleaned filter into the door opening.
Wash the filters occasionally in detergent solution using a soft brush to remove small particles.
Ensure that the filter is fully dry before next use.
If your filter becomes damaged, replace it to ensure no damage is caused to the dryer
