7. Turn the inverter rocker switch to the Inv+USB (I) position.
The LED Indicator Light should glow GREEN confirming
that there is power running to the inverter.
8. Turn the inverter rocker switch to the center OFF (O)
position. (The GREEN LED Power Indicator light may
“blink” briefly and/or the internal audible alarm may make
a momentary “chirp”. This is normal).
9. Confirm that the equipment or appliance to be operated is
turned off. Plug the equipment or appliance into one of the
three AC receptacles on the front panel of the the inverter.
10. Turn the inverter to the Inv+USB (I) position. Turn on the
equipment or appliance.
11. The USB can be powered independently of the inverter
by turning the rocker switch to the USB (II) position.
NOTE
: Indicator LED will not illuminate in this position.
NOTE:
• As indicated in Step 7 above, the audible alarm may make
a momentary “chirp” when the inverter is turned OFF (O).
The same alarm may also sound when the inverter is being
connected to or disconnected from the 12 volt power source.
• The use of an extension cord from the inverter to the appliance
or equipment being operated will decrease the power being
delievered to the load. For best operating results, the extension
cord should be no more than 50 feet long.
• Check frequently to ensure that the input and output
connections are secure. Loose connections may damage the
inverter or the power source or may generate excessive heat.
OPERATION
10
