www.whisperkool.com | Page 3
Receiving and Inspecting the Kit
•
Inspect the packaging for any obvious signs of damage or mishandling before opening the container.
•
Note any discrepancies or visual damage on the Bill of Lading before signing.
Review the Packing Slip to Verify Contents
•
Check the model number to ensure it is correct.
If any items listed on the packing slip do not match your order information,
contact WhisperKOOL Customer Service immediately.
STEP 1:
1. Inspect the Kit before installation. If damage is found, please contact your distributor or WhisperKOOL
Customer Service at 1-800-343-9463.
2. Verify that you have received all of the items on the “Components Provided” list below and that the Kit
corresponds with your specific WhisperKOOL cooling system.
3. The system is intended for use in properly designed and constructed wine cellars. Hire a professional wine
storage consultant with a valid contractor’s license to build your wine cellar.
4. WhisperKOOL requires that all Cold Weather Start Kits be installed by a certified HVAC-R technician only.
5. Warranty is not active until a Warranty Checklist has been received, reviewed, and approved.
RECEIVING & INSPECTING THE KIT
After verifying that you have received all of the correct components for your specific system, please keep the Cold
Weather Start Kit in its original box until you are ready for installation. This will allow you to move the product safely
without damaging it. When you are ready to remove the product from the box, refer to the installation instructions.
TIP: Save your box and all packaging materials. They provide the only safe means of transporting/shipping the unit.
Condensing Unit Components Provided:
•
(1) Cold Weather Start Kit Electrical Box
Assembly
•
(1) Thermal Switch Assembly
•
(1) H1 Lever Connector Assembly
•
(2) Silicone Heaters
•
(2) Yellow Female Disconnect
•
(1) Red Female Disconnect
•
(1) Closed End Terminal
•
(2) Hose Clamps
•
(25) Zip Ties
•
(3) Metal Zip Ties
•
(4) 1/2” Hex Head Self Tapping Screws
•
(1) Piece of Heat Shield
•
(1) Bag of Thermal Paste
•
Platinum Split 4000 Cold Weather Start Kit
Installation Manual
Evaporator Unit Components Provided:
•
(4) Lever Connectors
•
(1) 120v/24v Transformers (with double
sided tape on bottom and side edges
for mounting)
•
(5) Zip Ties (3 for install and 2 additional)
Components Needed (Not provided):
•
2 wire t-stat wire for routing from the
evaporator unit (Air Handler) to the
condensing unit.
•
Use 18-20 awg wire stranded or solid
Tools Needed:
•
#1 Philips Head Screw Driver
•
#2 Philips Head Screw Driver
•
5/16” Nut Driver
•
1/4” Nut Driver
•
Drill
•
Wire Cutters
•
Wire Strippers
•
Crimpers
•
Needle Nose Pliers
•
Utility Knife
