5
6.
Attach the plastic wing protector onto the center of
the top of the wing, flush with the rear edge (trailing
edge). Use either epoxy or thin double sided tape to hold
it in place.
7.
Find the decal sheet and cut off a strip of material
where indicated. Dress up the three wing joints by
covering them with this material.
TAIL ASSEMBLY
1.
Trial fit the stabilizer in place on the fuselage.
Center it on the fuselage; the elevator control horn
should be aligned with the centerline of the fuselage.
Use a felt-tip pen to trace where the fuselage sides meet
the bottom of the stabilizer.
2.
Remove the tail and VERY carefully use a sharp
hobby knife to cut the covering on the bottom of the
stabilizer about 1/16” on the INSIDE of the lines you just
traced onto the tail. Just score the covering film. DO
NOT cut into the wood or you will weaken the structure.
Carefully peel away the covering material in this area.
3.
Inside the fuselage’s wing
compartment, loosen the hex
screw that secures the elevator
pushrod on the elevator servo
horn. Pull this pushrod com-
pletely out of the fuselage.
Insert the “Z” bent end of the
pushrod into the second hole of the elevator control horn.
Then replace the pushrod in the rear of the fuselage,
sliding the assembly forward until the stabilizer is prop-
erly positioned. MAKE SURE you insert the pushrod
into its connector on the elevator servo horn as you move
Second Hole
Rear
Front
Elevator Servo
