Whirlpool WWPU75210, Instructions For Use Manual

Page: 14 / 60

14
Use and Care guide
2) CYCLE DURATION
• When a programme is selected the display
automatically shows the typical cycle duration,
which can vary, depending on the options
selected.
• During the initial filling phase of the cycle the
machine calculates the actual cycle time needed
based on the load size, content and options
selected. The real time of the wash will then be
displayed. This time can recaulculate during the
wash depending on detergent levels and load
balancing.
3) DOOR LOCKED INDICATOR LIGHT
• The indicator light is illuminated when the
door is fully closed.
• When START/PAUSE is pressed on the machine
with the door closed, the indicator will flash
momentarily and then illuminate.
• Wait until the DOOR LOCKED indicator light
has gone out before opening the door.
Kg LOAD INDICATOR LIGHT (function active
only on certain programmes)
• During the first minutes of the cycle, the “Kg
LOAD” indicator will remain on while the
intelligent sensor will weigh the laundry and
adjust the cycle time, water and electricity
consumption accordingly.
• Through every wash phase “Kg LOAD” allows
to monitor information on the wash load
in the drum and in the first minutes of the
wash it:
- adjusts the amount of water required;
- determines the length of the wash cycle;
- controls rinsing according to the type of
fabric selected to be washed it;
- adjusts the rhythm of drum rotation for the
type of fabric being washed;
- recognises the presence of too much soap
suds, and if necessary, adjust the amount of
rinse water.
- adjusts the spin speed according to the load,
thus avoiding any imbalance.
5) KEY LOCK INDICATOR LIGHT
The indicator light show that the keys are locked.
6) WASH TEMPERATURE INDICATOR LIGHTS
This shows the washing temperature of the
selected programme that can be changed
(where allowed) by the relevant button.
If you want carry out a cold wash all the indicators
must be off.
7) SPIN SPEED INDICATOR LIGHTS
This shows the spin speed of the selected
programme, that can be reduced or omitted by
the relevant button.
Close the door BEFORE selecting the START/
PAUSE button.
If the door is not properly closed, the light
will continue to flash for about 7 seconds,
after which the start command will be
automatically cancelled. In this case, close
the door in the proper way and press the
START/PAUSE button.