EN
7
Socket outlet / plug (valid for
both countries)
If the fitted plug is not suitable
for your socket outlet, contact
Customer Support for further
instruction . Do not replace the
plug on your own .This
operation must only be carried
out by a qualified technician, in
compliance with the
manufacturer's instructions
and the current safety
regulations .
CORRECT USE
Do not exceed the maximum
load allowed . Check the
maximum load allowed in the
programme chart .
Close the water tap when the
washer dryer is not in use .
Do not use any solvents (e .g .
turpentine, benzene),
detergents containing
solvents, scouring powder,
glass or general purpose
cleaners, and flammable fluids;
do not wash fabrics treated
with solvents or flammable
liquids in the washer dryer .
Do not over-dry the laundry .
Fabric softeners, or similar
products, should be used as
specified by the fabric softener
instructions .
Do not dry unwashed laundry .
CLEANING AND
MAINTENANCE
The appliance must be
disconnected from the power
supply before carrying out any
cleaning or maintenance
operation .
Never use steam cleaning
equipment .
corresponds to that of your
home .
For installation to comply with
current safety regulations, an
omnipolar switch with
minimum contact gap of 3mm
is required .
Regulation require that the
appliance is earthed .
For appliances with fitted plug,
if the plug is not suitable for
your socket outlet, contact a
qualified technician .
Do not use extension leads,
multiple sockets or adapters .
Do not connect the appliance
to a socket which can be
operated by remote control .
The power cable must be long
enough for connecting the
appliance, once fitted in its
housing, to the main power
supply .
Do not pull the power supply
cable .
If the power cable is damaged
it must be replaced with an
identical one . The power cable
must only be replaced by a
qualified technician in
compliance with the
manufacturer instruction and
current safety regulations .
Contact an authorised service
centre .
Do not operate this appliance
if it has a damaged mains cord
or plug, if it is not working
properly, or if it has been
damaged or dropped . Do not
immerse the mains cord or
plug in water . Keep the cord
away from hot surfaces .
The electrical components
must not be accessible to the
user after installation .
Do not touch the appliance
with any wet part of the body
and do not operate it when
barefoot .
ELECTRICAL CONNECTIONS
FOR GREAT BRITAIN AND
IRELAND ONLY
Fuse replacement
If the mains lead of this
appliance is fitted with a BS
1363A 13amp fused plug, to
change a fuse in this type of
plug use an A .S .T .A .
approved fuse to BS 1362 type
and proceed as follows:
1 . Remove the fuse cover (A)
and the fuse (B) .
2 . Insert the 13A replacement
fuse inside the cover .
3 . Insert both into the plug .
Important:
The cover must be re-installed
after having replaced the
fuse;if lost, the plug cannot be
used and must be replaced .
Correct replacement are
identified by the colour insert
or the colour embossed in
words on the base of the plug .
Replacement fuse covers are
available from your local
electrical store .
For the Republic of Ireland
only
The information given in
respect of Great Britain will
frequently apply, but a third
type of plug and socket is also
used, the 2-pin, side earth
type .
