14
If the Temperature Set is on
the proper position.
Advise the consumer. On
days too hot or with the
Refrigerator too full, the
Temperature selection
hould be set to maximum
po 1 ºC.
If there were excess door
openings or open doors.
Advise the consumer.
If the Fan motors
(Refrigerator & Freezer) is
working properly.
If not, test it , finding any
proble, replace it.
If any Alarm, was activated
Check orientation done on
this Manual, regarding
espective Alarm code.
The Sealed system
operation, as leakage or
restriction on the system,
low compressor pumping,
fluid charge and others.
Replaced the failure
component and do the
reoperation system.
If the electronic control –
PCB is working properly.
Check if all interface
components are working
well, if not, replace the
damaged component,if yes,
check the electronic control
– PCB.
Check the defrost system:
-defrost sensor should not
be opened, in short-ciuit or
out of position (evaporator
returning pipe)
-defrost heater &
thermofuse are opened/
burnt or improperly
positioned
-The electronic control –
PCB should be engaging
the defrost heater, do the
self test routine to prove it.
If the evaporator is blocked
by ice.
Check if the Gutter or
Defrosting Drain is blocked.
If the product is an alarm
mode.
Check orientation done on
this manual alarm – item,
regarding respective alarm
code shown on the
interface.
If the freezer fan motor is
working properly.
Check the fan motor,
electronic control and their
electric connectors, carring
out the self test routine.
Finding any problem, adjust
the contacts or replace the
damaged component.
The sealed system
operation, as leakage or
restriction on the system,
low compressor pumping,
fluid charge and others.
Replaced the failure
component and do the
reoperation system.
Does not freeze/
freezing not
much in the
freezer
If the electronic control –
pcb is working properly.
Check if all interface
components are working
well, if not, replace the
damaged component,if yes,
check the electronic control
– pcb.
If utensils are placed
directly on the cold air
outlet.
Reposition them and advise
the consumer.
If the door cooling is well
fitted / locked at the wind
flow
Fit the door cooling to the
correct position and advice
the consumer about its
function and the correct
position after cleaning
Freezing in the
refrigerator
compartment.
If the refrigerator
temperature set is on the
proper position.
Advise the consumer: on
days too cold or with few
food in the refrigerator, the
temperature selection
should be set to the
minimum position for both
compartment (freezer &
refrigerator).
Ice being formed
in the freezer.
Humidity infiltration through
the door.
Check for any object
blocking the door closing. If
gasket is defective, replace
it.
