COMPONENT ACCESS
4-6
n
Multi-Door Freestanding Refrigerator
Accessing Refrigerator Compartment Components (Continued)
Water Reservoir Cover
7.
Using a 1/4" (6.4 mm) nut driver remove the two screws from
under the water filter door.
8.
Starting from the ice box side, place a flat head screw driver
between the water reservoir cover and refrigerator
compartment liner creating enough room to place your hand
between the two.
9.
Working from left to right, slide your hand between the water
reservoir cover and refrigerator compartment liner to
disengage the snaps.
10.
Disengage rear left snap.
11.
To remove the water reservoir cover, slide it forward and
disconnect LED lighting connector.
LED Light Modules
12.
To remove LED light modules from water reservoir cover, lift
out.
NOTE: To remove LED modules from bottom of ice box
assembly and cabinet walls, protect the liner while using a
putty knife to pry them out.
A
A. Two screws
A
A. Snaps (not shown)
A
A. Snap
A
A. LED connector
Summary of Contents for WRV976FDEM
