6
Style 2
Turning the Ice Maker On/Off:
■
To turn ON the ice maker, simply lower the wire shutoff arm.
■
To manually turn off the ice maker, lift the wire shutoff arm to the
OFF (arm up) position and listen for the click. Ice can still be
dispensed, but no more can be made.
NOTE: The ice maker has an automatic shutoff to keep the storage bin
from overfilling during normal operation. As ice is made, the ice cubes
will fill the ice storage bin, and the ice cubes will raise the wire shutoff
arm to the OFF (arm up) position. Do not force the wire shutoff arm up
or down.
Removing and Replacing the Ice Storage Bin:
1. Pull the covering panel up from the bottom.
2. Lift the wire shutoff arm so it clicks into the OFF (up) position.
3. Lift up the front of the storage bin and pull it out.
4. Replace the bin by pushing it in all the way or the dispenser will not
work.
5. To restart ice production, lower the wire shutoff arm into the
ON (down) position. Make sure the door is closed tightly.
Water Filtration System
Water Filter Status Light
The water filter status light will help you know when to change your
water filter.
■
When the dispenser control panel’s water filter status display
changes to “ORDER,” this tells you that it is almost time to change
the water filter cartridge.
■
Replace the water filter cartridge when the water filter status display
changes to “REPLACE.”
NOTE: If water flow to your water dispenser or ice maker decreases
noticeably, change the filter sooner. The filter should be replaced at
least every 6 months, depending on your water quality and usage.
Resetting the Filter Status
■
After changing the water filter, reset the status light by pressing and
holding the FILTER button for 3 seconds.
When the system is reset, the “ORDER” and “REPLACE” icons will
disappear from the display screen.
Changing the Water Filter
1. Locate the water filter in the top-right corner of the refrigerator
compartment.
2. Lift open the filter cover door. The filter will be released and then
be ejected as the door is opened.
3. When the door is completely open, pull the filter straight out.
NOTE: There may be some water in the filter. Some spilling may
occur. Use a towel to wipe up any spills.
4. Take the new filter out of its packaging and remove the cap. Be
sure the O-rings are still in place after the cap is removed.
5. With the arrow pointing up, align the new filter with the filter
housing and slide it into place. The filter cover door will
automatically begin to close as the new filter is inserted.
6. Close the filter cover door completely in order to snap the filter into
place. You may need to press hard.
7. Flush the water system. See “Water and Ice Dispensers.”
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
