22
9.
Replace the oven door if it has been removed. See the “Oven
Door” section.
10.
Replace the oven racks
Complete Installation (Natural Gas to Propane
Gas)
1.
Refer
to
the
“Make
Gas
Connection”
section
for
properly
connecting
the
range
to
the
gas
supply.
2.
Refer
to
the
“Electronic
Ignition
System”
section
for
proper
burner
ignition,
operation
and
burner
flame
adjustments.
IMPORTANT:
You
may
have
to
adjust
the
“LO”
setting
for
each
cooktop
burner.
Checking
for
proper
cooktop,
bake
and
broil
burner
flame
is
very
important.
The
small
inner
cone
should
have
a
very
distinct
blue
flame
1/4"
(6
.
4
m
m)
to
1/2"
(1.3
cm)
long.
The
outer
cone
is
not
as
distinct
as
the
inner
cone.
Propane
gas
flames
have
a
slightly
yellow
tip.
3.
Refer
to
“Complete
Installation”
in
the
“Installation
Instructions”
section
of
this
manual
to
complete
this
procedure.
NOTE:
Make
sure
to
save
the
orifices
that
have
just
been
replaced
in
the
conversion.
Natural Gas Conversion
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death or
serious burns to children and adults.
1.
Turn manual shutoff valve to the closed position.
A. To range
B. Manual shut-off valve closed position
C. Gas supply line
2.
Unplug range or disconnect power.
To Convert Gas Pressure Regulator (Propane Gas
to Natural Gas)
1.
Remove
the
premium
storage
drawer,
warming
drawer
or
baking
drawer
or
premium
storage
drawer.
See
the
Remove
/
Replace
Drawer,
Storage
Drawer
or
Warming
Drawer
or
Premium
Storage
Drawer
section.
2.
Locate
gas
pressure
regulator
at
rear
of
the
drawer
compartment.
NOTE:
On
models
with
a
warming
drawer
or
baking
drawer,
an
access
cover
must
be
removed
to
access
the
gas
pressure
regulator.
A. Gas pressure regulator
IMPORTANT:
Do not remove the gas pressure regulator.
3.
Remove plastic cover from gas pressure regulator cap.
4.
Turn gas pressure regulator cap counterclockwise with a 5/8"
(1.6 cm) combination wrench to remove.
NOTE:
Do not remove the spring beneath the cap.
A. Plastic cover
B. Gas pressure regulator cap with hollow end facing out
C. Gas pressure regulator cap with solid end facing out
D. Washer
E. Gas pressure regulator cap
5.
Turn over the gas pressure regulator cap and reinstall on
regulator so that the solid end faces out and the marking
“↓NG” is facing the direction shown in the above drawing.
6.
Replace plastic cover over gas pressure regulator cap.
