3
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
■
Tape measure
■
Marker or pencil
■
Flat-blade screwdriver
■
Masking tape
■
Phillips screwdriver
■
Level
■
3
/
8
" (1 cm) and
5
/
16
"
(7.9 mm) nut driver
■
Hammer
■
Hand or electric drill
■
1
/
8
" (3.2 mm) drill bit
(for wood floors)
■
Wrench or pliers
Parts Supplied
Check that all parts are included.
■
Anti-tip bracket must be securely mounted to floor or wall.
Thickness of flooring may require longer screws to anchor
bracket to floor.
Parts needed
If using a power supply cord kit:
■
A UL listed power supply cord kit marked for use with
ranges. The cord should be rated at 250 volts minimum, 40
amps or 50 amps that is marked for use with nominal 1³⁄
8
"
(3.5 cm) diameter connection opening and must end in ring
terminals or open-end spade terminals with upturned ends.
■
A UL listed strain relief.
Check local codes. Check existing electrical supply. See
“Electrical Requirements” section.
It is recommended that all electrical connections be made
by a licensed, qualified electrical installer.
A
B
C
A. Anti-tip bracket
B. #12 x 1" screws (2)
C. Plastic Anchors (2)
Location Requirements
IMPORTANT:
Observe all governing codes and ordinances.
■
It is the installer’s responsibility to comply with the installation
clearances specified in this installation instructions. The
model/serial/rating plate is located under the storage drawer.
See the installation instructions on instructions on how to
remove the storage drawer.
■
Cabinet opening dimensions that are shown must be used.
Given dimensions are minimum clearances.
■
The anti-tip bracket must be installed. To install the anti-tip
bracket shipped with the range, see “Install Anti-Tip Bracket”
section.
■
Grounded electrical supply is required. See “Electrical
Requirements” section.
IMPORTANT:
To avoid damage to your cabinets, check with your
builder or cabinet supplier to make sure that the materials used
will not discolor, delaminate or sustain other damage. This oven
has been designed in accordance with the requirements of UL
and CSA International and complies with the maximum allowable
wood cabinet temperatures of 194°F (90°C).
Mobile Home - Additional Installation Requirements
The installation of this range must conform to the Manufactured
Home Construction and Safety Standard, Title 24 CFR, Part 3280
(formerly the Federal Standard for Mobile Home Construction
and Safety, Title 24, HUD Part 280). When such standard is
not applicable, use the Standard for Manufactured Home
Installations, ANSI A225.1/NFPA 501A or with local codes.
In Canada, the installation of this range must conform with
the current standards CAN/CSA-Z240-latest edition, or with local
codes.
Mobile home installations require:
■
When this range is installed in a mobile home, it must be
secured according to the instructions in this document.
■
Four-wire power supply cord or cable must be used in a
mobile home installation. The appliance wiring will need to be
revised. See “Electrical Connection - U.S.A. Only” section.
