COMPONENT ACCESS
27” Stacked Laundry Center
n
5-19
Removing the Washer Rear Panel
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
To Remove the Washer Rear Panel
1.
Unplug dryer or disconnect power.
2.
Perform the procedures on page 5-14, “Removing the
Dryer Assembly” prior to performing the following steps.
3. Remove Support Brackets.
Use a 5/16” driver to remove
the four (4) hex head screws indicated in Figure 1 to dis-
assemble the angle support bracket from the back of the
washer.
IMPORTANT
: To prevent damage to frame, do NOT remove
dryer support brackets with the dryer assembly installed.
Remove the 4
screws indicated.
Figure 1 - Support Bracket Screws
4.
Remove screw holding drain hose to rear panel. Use a flat
bladed screwdriver to unclip the drain hose bracket from
the rear panel. See arrow in Figure 1.
5. Remove Washer Rear Panel.
Use a 5/16” driver to remove
the six (6) hex head screws indicated in Figure 2, securing
rear panel to washer cabinet.
Figure 2
6
. Remove rear panel and set aside.
Summary of Contents for WET4027HW0
