13
Verify Anti-Tip Bracket Is Installed
and Engaged
On Ranges Equipped with a Premium Storage Drawer:
1.
Slide range into final location, making sure rear leveling leg
slides into anti-tip bracket.
2.
Remove the premium storage drawer. See the “Remove/
Replace Drawer” section.
3.
Use a flashlight to look underneath the bottom of the range.
4.
Visually check that the rear range foot is inserted into the slot
of the anti-tip bracket.
On Ranges Equipped with a Warming Drawer or Baking
Drawer:
1.
Slide range into final location, making sure rear leveling leg
slides into anti-tip bracket. Leave a 1" (2.5 cm) gap between
the back of the range and the back wall.
2.
Place the outside of your foot against the bottom front of the
warming drawer or baking drawer to keep the range from
moving, and then grasp the back of the range, as shown.
3.
Slowly attempt to tilt the range forward.
If you encounter immediate resistance, the range foot is
engaged in the anti-tip bracket. Go to Step 8.
4.
If the rear of the range lifts more than 1/2" (1.3 cm) off the
floor without resistance, stop tilting the range and lower it
gently back to the floor. The range foot is not engaged in the
anti-tip bracket.
IMPORTANT:
If there is a snapping or popping sound when
lifting the range, the range may not be fully engaged in the
bracket. Check to see if there are obstructions keeping
the range from sliding to the wall or keeping the range foot
from sliding into the bracket. Verify that the bracket is held
securely in place by the mounting screws.
5.
Slide the range forward, and verify that the anti-tip bracket is
securely attached to the floor or wall.
6.
Slide range back so the rear range foot is inserted into the
slot of the anti-tip bracket.
7.
Repeat steps 1 and 2 to ensure that the range foot is
engaged in the anti-tip bracket.
If the rear of the range lifts more than 1/2" (1.3 cm) off the
floor without resistance, the anti-tip bracket may not be
installed correctly. Do not operate the range without anti-
tip bracket installed and engaged. Please reference the
“Warranty” section of the User Guide to contact service.
Install Griddle
1.
Place the "FRONT" end of the griddle down, facing the oven
door. Verify that the lugs are placed onto the grate.
2.
Clean the griddle before using. Refer to the Use and Care
Guide for cleaning instructions. The griddle can be placed
over the left, right, or center burner.
Front
Lugs
Summary of Contents for WEG750H0HB
Page 70: ...70 Notas ...
Page 71: ...71 Notas ...
