background image

2

TABLE OF CONTENTS

DISHWASHER SAFETY

You Need to:

 

Slowly open dishwasher door while someone grasps the rear 

of the dishwasher. Remove shipping materials and drain hose. 

Close dishwasher door until latched.

NOTE:

 Each dishwasher is tested at the factory and may 

contain some residual water in the tub as a result of the test.

 

Observe all governing codes and ordinances.

 

Prepare dishwasher and faucet as specified in these 

instructions.

 

Have everything you need to properly install dishwasher. 

The dishwasher must be installed to meet all electrical and 

plumbing national and local codes and ordinances.

You can be killed or seriously injured if you don't immediately 
 

You

 

can be killed or seriously injured if you don't follow 

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.

Your safety and the safety of others are very important.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety 
messages.

This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”

These words mean:

follow instructions.

instructions.

DANGER

WARNING

WARNING

Tip Over Hazard

Do not use dishwasher until completely installed.
Do not push down on open door.
Doing so can result in serious injury or cuts.

DISHWASHER SAFETY ................................................... 2
INSTALLATION REQUIREMENTS ................................... 3

Tools and Parts .........................................................................3

Location Requirements .............................................................3

Water Supply Requirements .....................................................3

Electrical Requirements ............................................................3

INSTALLATION INSTRUCTIONS ..................................... 3

Caster Installation .....................................................................3

Prepare Dishwasher ..................................................................4

Connect Dishwasher .................................................................4

Disconnect Dishwasher ............................................................6

Summary of Contents for WDP340PAFB0







Reviews: