MSEX0025_rev01
15
b.3) Turn the product on and wait for the Thermometer to indicate -10ºC. This temperature corresponds to
the same Bimetal temperature. Then, disconnect the product from the socket and turn it on again.
(operation required for the sensor sends to the module the information that the product is cool, at a
temperature below zero degree).
b.4) Upon turning on the product again, the refrigerator will perform an automatic defrost after functioning
for 40 minutes.
As soon as the defrost starts, the Compressor and the Fan that are turned on will be turned off by the
Module and the Ammeter current comes near to zero;
b.5) In the following moment the Defrost Heater is actuated;
b.6) Monitor the refrigerator defrosting by the Ammeter Pliers for after a few minutes, the Bimetal opens its
contact and the current shown in the Ammeter Pliers display drops to near zero (the Heater was turned off).
Compressor and
Fan turned off
Check the current value
found against that
indicated in Item a.2 table,
according to product
model/ voltage
Heater
turned off
