10
IMPORTANT:
The drain hose connection of the disposer or a
waste tee must be made before the drain trap and at least
20" (50.8 cm) above the floor where the dishwasher will be
installed.
Helpful Tip:
To reduce vibration of the hose, keep the hose away
from the floor.
Option A, Waste Disposer – No Air Gap
Helpful Tip:
Remove disposer knockout plug.
Option B, No Waste Disposer – No Air Gap
Option C, Waste Disposer – With Air Gap
1.
Using a hammer and screwdriver,
knock plug into disposer.
2.
Use needle-nose pliers to remove
plug.
3.
Attach drain hose to disposer inlet
with large drain hose clamp
(provided). Use pliers to squeeze
clamp open and move into position.
1.
Fit rubber end of drain hose to waste
tee and cut if needed.
NOTE:
Do not cut ribbed section.
2.
Attach rubber end of drain hose to
waste tee with a large drain hose
clamp (provided). Use pliers to
squeeze clamp open and move into
position. If the drain hose was cut,
use a 1
¹⁄₂
" to 2" (3.8 to 5 cm) screw-
type clamp (not provided).
www.goedekers.com
Summary of Contents for W10741197A
Page 75: ...75 www goedekers com ...
