13
3.
Connect neutral wire
C
B
Place hooked end of neutral wire (white
or center) (C) of direct wire cable under
center terminal block screw (B), hook
facing right. Squeeze hooked end
together. Tighten screw.
4.
Connect remaining wires
Place hooked ends of remaining direct wire cable wires under
outer terminal block screws (hooks facing right). Squeeze
hooked ends together and tighten screws. Finally, reinsert tab
of terminal block cover into slot of dryer rear panel. Secure
cover with hold-down screw. Now, go to “Connect Outlet
Hose.”
Connect neutral ground wire (E) and neutral wire (white or
center wire) (C) of power supply cord or cable under center,
terminal block screw (B). Tighten screw.
Place ends of remaining wires under outer terminal block
screws. Tighten screws.
Optional External Ground for 3-Wire
Connection
(Power Supply Cord Shown)
IMPORTANT:
You must verify with a qualified electrician that
this grounding method is acceptable before connecting.
2.
Connect neutral ground wire and
neutral wire
C
E
B
1.
Prepare to connect neutral ground
wire and neutral wire
E
B
A
3.
Connect remaining wires
Install the correct strain relief for your electrical connection
method, as shown on page 8 or 11.
Remove center terminal block screw (B). Remove neutral ground
wire (E) from green external ground conductor screw (A).
Connect a separate copper ground wire (G) under the green
external ground conductor screw (A) to an adequate ground.
Finally, reinsert tab of terminal block cover into slot of dryer
rear panel. Secure cover with hold-down screw. Now, go to
“Connect Outlet Hose.”
4.
Connect external ground wire
G
A