21
Using a TORX
®
T25
®
screwdriver, remove the 2 screws
securing the door strike to the door frame of the dryer.
Remove the 4 screws above and below the door strike and
set aside for later use. Rotate the strike 180° and attach to
the opposite side of dryer door frame, as shown.
Position the door with the inside of the door facing up. Using
a Phillips screwdriver, remove the 13 screws securing the
inner door to the outer door. Lift off the inner door and set
aside.
NOTE:
There is a small release tab on each side of the door.
If the inner and outer door do not separate easily, slide a
credit card, putty knife, or similar flat object between the inner
and outer doors at the locations shown to release the tab.
Using a TORX
®
T25
®
screwdriver, remove the 3 TORX
®
screws
securing the latch plate and the 5 screws holding the hinge
assembly in place.
Using a TORX
®
T25
®
screwdriver, reinstall the latch plate and
hinge assembly on the opposite sides from which they were
removed.
