14
WASHER CARE (cont.)
Cancellation of Clean Washer Cycle Operation:
If the Clean Washer cycle is canceled by the user after it has
been initiated, it may take up to 30 minutes for the washer
to purge any affresh
®
Cleaner, chlorine bleach, or other
chemistry from the wash system and to adequately rinse any
remaining chemistry. The washer door will remain locked until
the cancellation process has been completed. This ensures
no cleaning chemistry will be carried over to the next wash
cycle and reduces the potential for damage to subsequent
loads of laundry or to the washer itself.
Clean Washer Cycle Cancellation Procedure:
1.
Touch POWER on the washer once.
2.
The washer will begin to drain and rinse away the
remaining cleaning chemistry.
3.
The cycle will complete the cancellation process in
approximately 30 minutes or less.
4.
The washer then can be used to either repeat the Clean
Washer cycle or to wash laundry using one of the regular
wash cycles selected by the user.
Cleaning the Dispensers
After a period of using your washer, you may find some
residue buildup in the washer’s dispensers. To remove
residue from the dispensers, remove the drawer and wipe
the surfaces with a damp cloth and towel dry either before
or after you run the Clean Washer cycle. Use an all-purpose
surface cleaner, if needed.
IMPORTANT: Dispenser is not dishwasher safe.
Cleaning the Outside of the Washer
Use a soft, damp cloth or sponge to wipe up any spills.
Occasionally wipe the outside of your washer to help
keep it looking new. Use mild soap and water.
IMPORTANT:
To avoid damaging the washer’s finish, do not
use abrasive products.
REMOVING THE DISPENSER
To remove:
1.
Pull dispenser drawer out until it stops.
2.
Press down on the release tab and pull straight out to
remove the dispenser.
3.
Lift off cover panel by
pulling straight up.
To replace:
1.
Slide cover panel back
onto posts on dispenser.
2.
Align edges of dispenser
with guides in washer,
then slide dispenser
back into slot.
CLEAN WASHER CYCLE REMINDER
The Clean Washer LED will
flash at the end of a wash
cycle when the washer has
run 30 wash cycles. This is a
reminder to run the Clean Washer cycle.
If the Clean Washer cycle is not turned on, the LED will
stop flashing at the end of a wash cycle after running 3
more regular wash cycles. After 30 more wash cycles are
completed, the Clean Washer LED will again flash at the end
of a wash cycle as a reminder.
WASHER MAINTENANCE
Summary of Contents for W10441071B
Page 24: ...24 SÉCURITÉ DE LA LAVEUSE ...
