17
If the door falls open, increase the spring tension by moving the
spring end toward the back of the dishwasher.
NOTE:
Springs should be in the same notches on left and right
sides.
IMPORTANT:
If rear leveling legs were removed, cover the floor
when moving the dishwasher to avoid damage to the floor. Slowly
move dishwasher completely into cabinet opening. Do not kink or
pinch water line, drain hose, power supply cord or direct wire
between dishwasher and cabinet. Remove cardboard from under
dishwasher.
NOTES:
■
It is all right if dishwasher fits tightly into cabinet opening. Do
not remove insulation blanket – the blanket reduces the sound
level.
■
If using power cord, make sure to route end through hole in
cutout before sliding dishwasher into cabinet opening.
Align front of dishwasher door panel with front of cabinet doors.
You may need to adjust alignment to be even with your cabinets.
Check that leveling legs are firmly against the floor. Close and
latch the door, and place level against the front panel. Check that
dishwasher is centered from front to back in the opening. If
needed, adjust leveling leg until dishwasher is plumb. Repeat for
other side of dishwasher.
Helpful Tip:
Push up on front of dishwasher to raise dishwasher
off the ground to adjust front legs. With some installations, it may
be easier to adjust the front leg using the
³⁄₁₆
" hex head socket or
adjustable wrench.
Place level against top front opening of tub. Check that
dishwasher is level from side-to-side. If dishwasher is not level,
adjust front legs up or down until dishwasher is level. Close the
dishwasher door.
Summary of Contents for W10435039A
Page 5: ...5 ...
