Whirlpool SF310BEG, Use And Care Manual

Page: 10 / 28

10
USING YOUR RANGE
1.
Press CLOCK. The colon flashes during
clock programming.
2.
Set the time.
Press the “up” (
▲
) or “down” (
▼
) pad(s) until
the correct time shows on the display.
NOTE: Press a pad briefly to change time by a
small amount. Press and hold a pad to change
time by 10 minute increments.
3.
Press CLOCK again to start the clock. The
colon stops flashing when the clock is active.
T
HE ELECTRONIC TIME
-
OF
-
DAY
(
TOD
)
CLOCK
/
TIMER
S
ETTING THE CLOCK
CLOCK
TIMER
TIMER
Oven
timer pad
(p. 11)
Display/clock
• When you first plug in the range, the display
flashes time-of-day. If, after you set the clock
(see “Setting the clock” section), the display
flashes, your electricity was off for a while. Reset
the clock.
• When showing the time of day, the display will
show the hour and minutes.
Electronic display
Clock
pad
(p. 10)
Increase
pad
(p. 10, 11)
Decrease
pad
(p. 10, 11)
•
When you are using the timer, the display
will show seconds for time less than 1 minute,
minutes for time less than 1 hour, and hours
and minutes for time over 1 hour. The timer
indicator will be lit when in the timer mode.
PRESS YOU SEE
PRESS YOU SEE
PRESS YOU SEE