16
1.
Remove door from dryer
2.
Move the door strike
Using a T25
®
screwdriver, remove the 2 screws securing
the door strike to the door frame of the dryer. Rotate the
strike 180° and attach to the opposite side of dryer door
frame, as shown.
3.
Remove inner door from outer door
Position the door with the inside of the door facing up.
Using a Phillips screwdriver, remove the 10 screws securing
the inner door to the outer door. Lift off the inner door and
set aside.
IMPORTANT:
If the protective film has not yet been removed
from the dryer, peel the film from the dryer door before
proceeding.
Using a TORX
T25
®
screwdriver, remove the 4 screws securing
the door hinge to the dryer and lift up and out to remove the
door. Place the door on a soft towel or other non-scratch
surface. Reinstall the 4 screws in the holes.
Reverse door swing round-shaped door – single handle
#2 Phillips screwdriver
Min. 8" long TORX
T25
® †
screwdriver
Tools needed:
†
® TORX and T25 are registered trademarks of Acument Intellectual Properties, LLC.
Door Reversal (optional)
The following instructions are for models with a round and
square-shaped doors.