Whirlpool HGA 6.5 AM X/HA, Operating Instructions Manual

Page: 35 / 84

GB
35
Installation
7KHLQVWDOODWLRQSURFHGXUHLVLOOXVWUDWHGLQWKH¿UVWSDJHV
of this manual.
7KHLQVWDOODWLRQPXVWEHGRQHE\DTXDOL¿HGWHFKQLFLDQ
Electrical hook up
The mains voltage must match that given on the ratings
label inside the hood itself. If the hood has a power plug,
connect the hood to an easily accessible regulatory power
socket. If it does not (direct connection to the mains), or the
VRFNHWLVQRWHDVLO\DFFHVVLEOHLQVWDOODWZRSROHUHJXODWRU\
switch to enable total disconnection from the mains in case
of category III overvoltage, as required by the installation
regulations.
Caution! Always check that the mains cable is hooked
up properly and check that it operates correctly before
reconnecting the hood to the mains.
Air exhaust
(for ducted units)
Connect the hood to a duct and wall exhaust hole of a
GLDPHWHUHTXDOWRWKDWRIWKHDLURXWOHWÀDQJH8VLQJDVPDOOHU
diameter tube and exhaust hole reduces the extraction
capacity of the hood and also increases its running noise.
The manufacturer is not liable for any consequences of
doing so.
!
Use the shortest duct required to achieve the purpose.
!
Use a duct with as few bends as possible
!
Avoid suddenly changing the diameter of the duct.
!
The duct must have as smooth an inner surface as
possible.
!
The duct must be made of regulatory material.
!
'R QRW FRQQHFW WKH KRRG WR ÀXHV FDUU\LQJ FRPEXVWLRQ
fumes from other equipment (boilers, GLASSs, stoves, etc.).
!
Observe the instructions of the competent authorities in
relation to the air exhaust. The air being exhausted may not
be exhausted into a wall cavity unless the cavity in question
LVVSHFL¿FDOO\LQWHQGHGIRUWKLVSXUSRVH
!
Equip the room with air intakes to prevent the hood creating
suction pressure in the interior (this must not exceed 0.04
mbar).
!
The manufacturer is not liable for any consequences of
failure to observe these instructions.
Filter or ducted?
!
<RXUKRRGLVVXSSOLHGDVDGXFWHGXQLW
,I\RXZLVKWRXVHLWDVD¿OWHUXQLW\RXPXVWLQVWDOOWKHSURSHU
$&&(6625<.,7
Note: If supplied with the hood, the accessory active
FKDUFRDO¿OWHUXQLWPD\DOUHDG\EHLQVWDOOHG
Instructions for transforming the hood from the ducted to the
¿OWHUYHUVLRQDUHJLYHQLQWKLVPDQXDOVHH³)LOWHUYHUVLRQ´
Ducted version
7KH KRRG SXUL¿HV WKH DLU DQG H[SHOV LW RXWGRRUV YLD DQ
H[KDXVWGXFWGLDPPFRQQHFWHGWRLWVRXWOHWÀDQJH
The diameter of the exhaust tube must be equal to that of
WKHRXWOHWÀDQJH
Caution! The exhaust duct is not supplied and must be
purchased separately.
When routed horizontally, the tube must be angled slightly
upwards (around 10°) to enable the air to be conveyed
RXWGRRUV PRUH HDVLO\ ,I WKH KRRG LV ¿WWHG ZLWK FKDUFRDO
¿OWHUVWKH\PXVW¿UVWEHUHPRYHG
Filter version
7KHKRRGSXUL¿HVWKHDLUDQGUHWXUQVLWWRWKHURRP7KLV
version of the hood requires installation of an accessory
DFWLYHFKDUFRDO¿OWHUXQLW
7KLVYHUVLRQUHTXLUHVDQDLUGHÀHFWRUDUHGXFWLRQDGDSWHU
DQG WKH FKDUFRDO ¿OWHUV 7KH WRS WXEH PXVW KDYH LWV DLU
outlet slots uppermost.
Technical data
Model
Height
(cm)
Width
(cm)
Depth
(cm)
dia. of
exhaust tube
(cm)
GLASS 60cm 59.8 50 15/12
GLASS 90cm 89.9 50 15/12
Model code Bulb (V) Bulb draw (W) Total draw (W)
+*)6$%;+$
+*$6$%;+$
+*$6$%;+$
Halogen 2 x 40 185
Model code Bulb (V) Bulb draw (W) Total draw (W)
+*)$';+$
+*$$';+$
+*$$',;+$
+*)$';+$
Halogen 2 x 40 290
Model code Bulb (V) Bulb draw (W) Total draw (W)
+*$$0;+$
+*)$0;+$
+*$$0;+$
+*)$0;+$
Halogen 2 x 40 150
The hoods are conforming to the following EC
Directives:
‡³/RZYROWDJH´'LUHFWLYH(&
‡³(0&´'LUHFWLYH(&