3
P
ROCEDURE
1. Find a suitable installation position of hood which
should be next to a window and can be cut to let
the exhaust duct pass through.
2. If the exhaust duct has to pass through the wall,
particular attention must be paid to the structure of
the wall as steel reinforcement may be embedded.
3. Mark the location of exhaust outlet hole, then cut/
drill the hole with care.
4. Fix the position of hood and mark the position of
the two hanging hooks.
5. Drive 2 steel nails into the selected wall with 3 mm
(maximum)space leave behind for hanging the hood.
6. Adjust the hanging hooks on both sides of the hood
and hang the hood on the steel nails, and then
adjust the hood from side to side and from front
and back to a horizontal position.
7. Follow the instruction print on the enclosed exhaust
duct adapter and connect the exhaust duct adapter
to the hood and window/wall. 5-inch or 6-inch duct
can be used.
8. Fasten the hanging bracket to the wall by screws
from the fixed holes to avoid of being hanged up
by accident.
9.
To ensure drainage performance, hood shall be
installed with slope (2 - 4 mm) as shown in figure.
And rubber cushion(at rear housing) MUST
NOT be removed, otherwise appliance will be
operated unstable/noisy and water leakage.
3mm(maximum limit)
Level
Tilted
X
Adjust the hang hood and
prepare to install
Drill a hole for the air tube Drive 2
steel nails in, on the upper corner
of the both side of the hood.
Keeps the hood in level to avoid
the oil leaking from oil cup.
2-4mm
screw
Wall
Exhaust
duct
Plywood
Summary of Contents for HAS2831S
