13
Connect to water supply
Helpful Tip:
Compression fittings:
a. Slide nut onto copper tubing about 1" (2.5 cm).
b. Slide ferrule onto the tubing. Do not position ferrule
on the end of the tubing.
c. Put the tubing into the elbow as far as it will go.
d. Slide the nut and ferrule forward and start the nut
onto the elbow threads. Be gentle when handling
and positioning the copper tubing, it bends and kinks
easily.
1.
To prevent vibration during operation, route the water
supply line so that it does not touch the dishwasher
base, frame or motor.
2.
With copper tubing pushed into compression fitting as
far as it will go, use a wrench and tighten compression
fitting nut to elbow on water inlet valve.
3.
Place paper towel under elbow. Turn on water supply
and check for leaks.
Connect to drain
1.
To help minimize
vibration, route drain
hose to avoid contact
with motor, door springs,
water line, cabinet,
flooring or the edge of
the hole where it passes
through the cabinet.
2.
Do not remove drain
loop from side of
dishwasher.
3.
Place pan under end of drain hose. Pan will collect any
water in drain hose.
nut
ferrule
elbow
5.
Securely tighten ground connector.
6.
Tighten clamp connector or
conduit connector screws.
7.
Reinstall terminal box cover with
wires inside terminal box.
The cover must be outside the box
on the left side.
8.
Make sure no wires are pinched by cover.
Option 2, Power supply cord method
1.
Plug into a grounded 3 prong outlet.
2.
Check that power supply cord does not touch
dishwasher motor or lower part of dishwasher tub.
ground wire
washer
ground
connector
ground wire
screws
ADVERTENCIA
AVERTISSEMENT
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
drain
loop
Summary of Contents for GU3600XTV
Page 16: ...NOTES ...
Page 32: ...W10021230 2006 Printed in U S A Imprimé aux É U 05 2006 ...
