4-3
Maintop
Venturi
Ignitor Screw
Spark Ignitor
Gas Line
Tubing
Lift Bracket
See Inset
Burner Box
Insert Venturi
Pin Here
Venturi
Mounting Screw
Bracket
Bracket Screw
Front Of
Burner Box
Ignitor Wire
Bracket
INSET
Unhook At Back
Of Burner Box
WARNING
Electrical Shock Hazard
Disconnect from electrical and gas supplies
before servicing unit.
Failure to do so could result in death, elec-
trical shock, or explosion.
CAUTION:
When you work on the cooktop, be
careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
1.
Turn off the gas supply and electrical
power to the cooktop.
2.
Remove the maintop from the burner box
(refer to page 4-2 for the procedure).
Figure 4-2
Refer to Figure 4-2 for the following steps.
3.
Remove the mounting screw from the
front of the bracket that contains the ven-
turi or spark ignitor you wish to service.
4.
Remove the tubing and ignitor wires from
each venturi and spark ignitor on the
bracket.
5.
Lift the front of the mounting bracket, re-
move the mounting screw from the ven-
turi, and remove the venturi. NOTE: You
may have to completely remove the bracket
to remove the venturi. If so, lift it at the
front, and unhook the back tab from the
burner box (see the inset).
6.
To service the spark ignitor, first note the
hole location for the ignitor before you
remove it. Then, remove the mounting
screw, and remove the ignitor from the
venturi.
REMOVING A VENTURI & SPARK IGNITOR
Summary of Contents for GLT3014G
