Whirlpool GAS FURNACE, User Instructions

Page: 8 / 12

8
TROUBLESHOOTING
First try the solutions suggested here and possibly avoid the cost of a service call.
Unit fails to operate
■
Check the following:
Is the main switch that supplies power to the unit in the ON
position?
Is the manual gas control valve in the OPEN position?
Has a fuse blown, or has the circuit breaker tripped? If
problem continues, call an electrician.
Is the thermostat set properly? See “Adjusting the Controls.”
Unit is operating but not providing complete comfort
■
Check the following:
Is the thermostat set properly? See “Thermostat Control.”
Is the filter clean? Replace or clean filter. See the “Filter
Maintenance” section.
Is the air able to circulate freely throughout your home? Do
not block supply registers or return grilles with furniture
or rugs.
ASSISTANCE OR SERVICE
If you need further assistance, you can write to the below
address with any questions or concerns:
Whirlpool ® Home Cooling and Heating
14610 Breakers Drive
Jacksonville, FL 32258
Please include a daytime phone number in your correspondence.
Replacement Parts
To order replacement parts contact your Whirlpool ® Home
Cooling and Heating dealer.
Gas Control Group
Heat Exchanger Group
Blower Group
Inducer Group
Electrical Group
■
Manifold
■
Burner
■
Orifice
■
Flame sensor
■
Gas control valve
■
Hot surface igniter
■
Ignition control
■
Primary heat exchanger
■
Secondary heat exchanger (if used)
■
Condensate drain pan (if used)
■
Blower housing assembly
■
Blower wheel
■
Blower motor
■
Blower motor mount
■
Capacitor
■
Pressure switch
■
Inducer blower
■
Limit control
■
Transformer
■
Rollout switch
■
Auxiliary limit (if used)
■
Blower door interlock
switch