40
Display message
Possible Cause
Possible Solution
FdL
(or F29)
The door cannot unlock .
Firmly press the door on the area
of the door lock, then press On/Off
for at least 3 seconds .
If hot cycle is selected, wait until
cool down and press again On/Off
for at least 3 seconds .
Switch on the washing machine .
If failure still appears, check and
eventually remove possible cause
as indicated for failure “Clean
filter” . Then switch the washing
machine on again . If door does
not unlock, press On/Off for at
least 3 seconds .
If door still does not unlock, refer
to section “DOOR – HOW TO OPEN
IT IN CASE OF A FAILURE” . Before
draining water / opening the door,
wait until the water has cooled
down (for hot wash programmes) .
Fod
Excessive foam formation
(maybe by overdosage of
detergent) interrupted the
programme . The interruption
can be repeated several times
until the foam reduction is
sufficient .
Start “Rinse&Spin” programme,
with option Intensive Rinse .
Respect the dosing
recommendations by the
detergent manufacturer .
Adjust and use the Dosing Aid
function .
Make sure that the water filter is
clean .
Summary of Contents for FSCR12420
