38
Before Use
Check Water Tank
Positioning
Operation Condition
·
Water Tank must be properly installed otherwise it will not start.
CAUTION: There may be some water left in the water tank from the product inspection in
factory. This is not a malfunction.
CAUTION: Do not use the product in
below area
•
With a lot of chemicals are used such
as factory, hospital, laboratories
•
With a lot of flammable gas or oil
•
With a lot of steam or oil such as
kitchen
•
With a lot of sulfide gas such as hot-
spring are
−
“Be
ep
”
s
ounds indicate connect to power source
−
A
t this moment, no icon
light up in the control panel.
−
All keys are no response, except “POWER” key and
Timer Key.
−
Press “POWER” to start the machine
·
Operation ambient temperature 5°C - 35°C
·
Operation ambient humidity RH% >30%
·
220V AC power supply only
·
Plugging Power plug into power socket
WARNING: Do not use in the following
places
·
Directly sunshine
·
Outdoor
·
Narrow space environment such as
inside cabinet
·
With a lot of steam or oil such as
kitchen
CAUTION:
·
Display shows "HI", when the room
relative humidity is higher than
80%, at this moment,
the unit
operates as normal.
·
Display shows "LO" when the room
relative humidity is lower than
35%,
at this moment, compressor
will
stop operation.
·
Place the unit in an upright position
·
On a stable and flat surface. Carpet or futon is
an
unstable place. Do not place above
floor level such as on table.
·
Enough space around the unit.
(R
ecommended space: Upper 50cm or more; Side 20 cm
or more; Water tank side 20cm or more; Behind 20cm or more; Front; 20cm or more)
·
Avoid place in direct sunlight
·
Any electric machine in the same space, if there is noise or cannot display correct time,
move the product far as far as possible.
Air outlet
Air intake
50cm or above
20cm or
above
20cm or above
20cm or
above
20cm or above
