Whirlpool Cabrio W10164752A, Use & Care Manual

Page: 22 / 52

22
To use d ryer again
1. Flush water pipes. Reconnect water inlet hose to faucet. Turn on
water faucet.
2. Plug in dryer or reconnect power.
3. Open valve to gas supply line.
Moving care
1. Unplug the power supply cord.
2. Shut off water faucet.
3. Disconnect the water inlet hose from faucet, then drain the hose.
Transport hose separately.
4. Close shutoff valve in gas supply line.
5. Disconnect gas supply line pipe and remove fittings attached to
dryer pipe.
6. Cap the open fuel supply line.
7. Make sure leveling legs are secure in dryer base.
8. Use masking tape to secure dryer door.
Reinstalling the d ryer
Follow the “Installation Instructions” to locate, level, and connect the
dryer.
Changing the Drum Light
The dryer light automatically turns on inside the dryer drum when
you open the door.
To change the d rum light
1. Unplug dryer or disconnect power.
2. Open the dryer door. Locate the light bulb cover on the back wall
of the dryer. Remove the screw located in the lower right corner of
the cover. Remove the cover.
3. Turn bulb counterclockwise. Replace the bulb with a 10-watt
appliance bulb only. Replace the cover and secure with the screw.
4. Plug in dryer or reconnect power.
TROUBLESHOOTING
First try the solutions suggeste d here or visit our we b site an d reference FAQs (Frequently Aske d Questions) to possi b ly
avoi d the cost of a service call...
In U.S.A. www.whirlpool.com/help - In Cana d a www.whirlpool.ca
Dryer Operation
Dryer will not run
■ Has a househol d fuse b lown, or circuit b reaker trippe d ?
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
■ Was a regular fuse use d ?
Use a time-delay fuse.
■ Is the d ryer d oor firmly close d ?
■ Was the Start b utton firmly presse d ?
Large loads may require pressing and holding the Start button
for 2-5 seconds.
No heat
■ Has a househol d fuse b lown, or has a circuit b reaker
trippe d ?
The drum may be turning, but you may not have heat. Replace
the fuse or reset the circuit breaker. If the problem continues, call
an electrician.
■
Is the valve open on the gas supply line?
Unusual soun d s
■ Has the d ryer ha d a perio d of non-use?
If the dryer hasn’t been used for a while, there may be a
thumping sound during the first few minutes of operation.
■
Is a coin, b utton, or paper clip caught b etween the d rum an d
front or rear of the d ryer?
Check the front and rear edges of the drum for small objects.
Clean out pockets before laundering.
■ Is it a gas d ryer?
The gas valve clicking is a normal operating sound.
■
Are the four legs installe d , an d is the d ryer level front to
b ack an d si d e to si d e?
The dryer may vibrate if not properly installed. See the
Installation Instructions.
■ Is the clothing knotte d or b alle d up?
When balled up, the load will bounce, causing the dryer to
vibrate. Separate the load items and restart the dryer.
Dryer d isplaying co d e message
■ “PF” (power failure), check the following:
Was the drying cycle interrupted by a power failure?
Press and hold START to restart the dryer.
■ “F” Varia b le (F1, F2, F20, etc.) service co d es:
Call for service.