13
Reverse the strike
1.
Remove the door strike from the dryer door opening.
2.
Remove the cosmetic screw opposite the door strike.
A
B
A. Door strike
B. Cosmetic screw
3.
Reinstall the door strike and cosmetic screw on the opposite side
of the dryer door opening from where they were removed.
NOTE:
Door strike and plugs must be on the same side of the
dryer door opening.
Reinstall the
d
oor
1.
Remove the 4 screws and 2 hinges from the dryer door.
2.
Replace the 4 screws in the same holes.
3.
Remove the 4 screws from the opposite side of the door.
4.
Install the 2 hinges to the front panel of the dryer using 4 screws.
Use the non-slotted side to attach the hinge to the front panel.
5.
Install screws in the top hinge holes in the door. Do not tighten
screws. Leave approximately ¼" (5 mm) of screw exposed.
A
A
A. Install these screws first.
6.
Hang door by placing screw heads into top slotted holes of
hinges and slide door down. Align bottom screw holes in hinge
and door. Install two bottom screws. Tighten all hinge screws.
7.
Close door to engage door strike.
Complete Installation
1.
Check that all parts are now installed. If there is an extra part, go
back through the steps to see which step was skipped.
2.
Check that you have all of your tools.
3.
Dispose of/recycle all packaging materials.
4.
Be sure the water faucets are on.
5.
Check for leaks around “Y” connector, faucet, and hoses.
6.
Check the dryer’s final location. Be sure the vent is not crushed or
kinked.
