3
HOW TO PROCEED IF…
...you want to check the dryer yourself first:
(If your machine is not functioning correctly, please check the
following points before calling the customer service – also refer to relevant chapter in the Instructions for Use)
Drying takes too long /
Laundry is not dry
enough
•
Was the inserted laundry too wet? (washing machine spin speed less
than 1000 rpm)
•
Is the lint filter dirty? (filter indicator light on)
•
Is the heat exchanger dirty? (for more information, refer to the
Instructions for use)
•
Is the room temperature too high?
•
Are the
“End”
and
“Anticrease”
indicator lamp lighting up?
The drying cycle is complete and the laundry can be taken out.
•
If the drying result does not meet your expectation, select a drier
programme or use the dryness adjustment option (if available).
•
Are thin and thick laundry mixed? Are different types of materials
mixed? Sort the laundry by thickness and material, then dry it again.
The dryer does not
operate (after a power
failure, always press
the “Start (Pause)”
button)
•
Is the plug properly inserted into the mains electricity socket?
•
Is there a power failure?
•
Has the fuse blown?
•
Is the door properly closed?
•
Has a drying programme been selected?
•
Has the
“Start (Pause)”
button been pressed?
•
Has the start delay option been selected?
•
Is the dryer overloaded?
Æ
Please remove a part of the load.
Lint filter, water
container or heat
exchanger indicator
lamp on
•
Is the lint filter clean?
•
Is the water container empty?
•
Has the water container been inserted correctly?
•
Is the heat exchanger clean and inserted correctly?
Water droplets
underneath the dryer
•
Has the heat exchanger been inserted correctly?
•
Have all lint on the heat exchanger seal and the door seal been
wiped away?
•
Has the water container been inserted correctly?
•
If the direct drain connection is used, is it tight?
•
Is the dryer levelled?
...you want to care of and clean your dryer:
Clean the filter at the
end of every cycle
•
Brush lint using a soft brush or your fingertips.
•
Close the filter.
•
Push the filter back into place.
Empty the water
container at the end of
every drying cycle
•
Pull the handle to remove the water container.
•
Empty the water container.
•
Replace the water container by pushing it fully
back into place.
Clean the heat
exchanger at least
once a month
•
Clean the heat exchanger under running water.
•
Remove all lint from the seals.
•
Clean the heat exchanger housing (for further information see
section
“Cleaning the heat exchanger”
in the Instructions for Use).
