33
Worktop for built-under models
The appliance
must
only be installed beneath a continuous fitted kitchen worktop.
If the appliance will be built under
it is mandatory
to use the cover panel UBS. This can be obtained
from specialist shops or from After-Sales Service.
1.
Unplug the appliance.
2.
Unscrew the worktop fixing screws from the rear of the appliance.
3.
Slide the worktop fully backward and lift it upwards to remove. Install the cover panel following the
relative instructions.
4.
Refit the fixing screws and tighten them.
5.
Plug the appliance only into the mains power socket.
Connect the water inlet hose
For models with straight hose A
1.
Insert the dirt strainer (already premounted on the
hose end or included in the accessories) into the
threaded tap coupling.
2.
Carefully screw the hose connection onto the tap
preferably by hand.
3.
Make sure there are no kinks in the hose.
4.
Check water-tightness of tap and appliance connections
by turning the tap completely on.
If the hose is too short, replace it with a suitable length
of pressure resistant hose (1000 kPa min, EN 50084
approved type).
Periodically check the hose for brittleness and cracks and
replace if necessary.
The appliance can be connected without an anti-
backpressure valve.
For models with Water Stop hose B
If the flexible hose is damaged, unplug the appliance from
the mains immediately.
1.
Screw the threaded connector with the filter inserted
onto the tap.
2.
Check water-tightness of tap and appliance connections
by turning the tap completely on.
If the hose is too short, replace it with a 3 m Water Stop
hose (available from After-Sales Service or from your
dealer). This operation must be carried out exclusively by
a licensed electrician.
The appliance
must not
be connected to the mixing tap
of a non-pressurized water heater.
The inlet hose and the plastic enclosure at the tap
connection contain electrical components.
Do not cut the
hose and do not immerse the plastic enclosure in
water.
A
B
3gb05221.fm5 Page 33 Tuesday, September 4, 2001 6:13 PM
