Whirlpool AWM 6100, Service Manual

Page: 19 / 22

WHIRLPOOL CONSUMER SERVICES
Model AWM6100
Page 19 of 22
TEST SEQUENCE
LED * Step Advance to step
by pressing :
(See Note 1)
Pump Out
or Fill Via
: Temperature Time Drum
Rhythm Component(s)
Checked
P W R RH D
1 Start Pump out - - Stationary Rinse hold and
Intensive rinse
buttons
2 Advances
automatically Prewash Cold fill, no
heat
60 s (fill) Stationary Prewash button
and prewash fill
3 Prewash button Main
wash Warm fill, no
heat 60 s (fill) Stationary Main wash fill
4 Easy iron button Main
wash Warm fill,
heat to 90°C 60 s (fill)
25 min
heat 10 s on,
6 s off Heating circuit,
NTC, leakage
5 Auto (or press
rinse hold button)
(Note 2) Main
wash Cold fill, no
heat 55 s (fill) 80 s on,
2 s off Easy ironing
button
6 Rinse hold button Fill via
fabric
softener Cold fill, no
heat 60 s 80s on,
2s off Fabric softener fill
7 Rinse hold button Pump out - 10s on,
6s off Pump
8 Advances
automatically
(Note 3) Pump out - 6 min Spin Max
speed Pump, spin
*Programme Sequence LED's: P = Prewash W = Wash R = Rinse RH = Rinse Hold D = Drain
Note 1 Unless indicated by "Advances automatically", the test cycle can only be advanced by
pressing the appropriate button once within five minutes, otherwise the machine will
pump out and a false fault will be indicated.
Note 2. This part of the test sequence can be terminated after the fill by pressing the "Rinse
hold" button but the NTC will not be checked for accuracy.
Note 3. This part of the test sequence can be terminated at any time by changing the cycle on
the cycle selector then reselecting drain and press the start button. Once the machine
is empty of water, the start button may be pressed and held until the start button light
goes off to reset the timer ready for the next wash.
If a failure is detected during the test sequence the timer will :
1. Initiate the safety step routine :
A. Drain pump runs until pressure switch resets plus 30 seconds.
I. Main motor is turned off.
II. Water inlet valves are turned off.
III. Element is turned off
2. Stop the machine and illuminate the speed indicator LED's in a pattern to indicate the
fault code.