Whirlpool AW05CR1SRHUE, Use & Care Manual

Page: 10 / 31

10
Filter Monitor
1. When Filter Monitor indicator light is lit , remove , clean and
replace air filter . See “Cleaning the Air Filter” .
2. Press FILTER MONITOR after cleaning and replacing the air
filter . This resets the filter monitor .
NOTE : After 360 hours of fan operating time , the filter indicator
light will turn on . It will remain on for 180 hours or until you press
FILTER MONITOR . After 180 hours , it will turn off automatically .
Temperature
■
Press the plus TEMP button to raise the temperature . Each
time you press or hold the plus TEMP button , the
temperature will go up 1° F (1° C ) until it reaches 90° F (32° C ).
NOTE : After 5 seconds , the display will show the current
room temperature .
■
Press the minus TEMP button to lower the temperature . Each
time you press or hold the minus TEMP button , the
temperature will go down 1° F (1° C ) until it reaches 64° F
(18° C ).
NOTE : After 5 seconds , the display will show the current
room temperature .
Timer Delay
To set the Timer for a 30- minute to 24- hour delay until the
air conditioner turns off ( the air conditioner must be On ):
1. Press TIMER . Timer indicator light will flash . Display will show
remaining hours before the air conditioner will turn off .
2. Press the plus or minus TEMP button to change the delay
time from 30 minutes to 24 hours .
3. After 5 seconds , Timer indicator light will remain on . Display
will show the current room temperature .
To set the Timer to turn on the air conditioner , keeping
previous settings :
1. Turn off air conditioner .
2. Press TIMER . Timer indicator light will flash . Display will show
remaining hours before the air conditioner will turn on .
3. Press the plus or minus TEMP button to change the delay
time from 30 minutes to 24 hours .
4. After 5 seconds , Timer indicator light will remain on . Display
will show the current room temperature .
To set the Timer to turn on the air conditioner , changing
the previous settings :
1. Turn on air conditioner .
2. Adjust the mode to Cool , Dry,Fan or Power Saver .
3. For Cool mode :
■
Adjust fan speed to High , Med , Low or Auto .
■
Adjust temperature between 64° F and 90° F (18° C and
32° C ).
4. For Fan mode , adjust fan speed to High , Med or Low .
NOTE : In Fan mode , temperature cannot be set .
5. For Dry mode , adjust temperature up or down by 4° F (2° C ).
6. Turn off air conditioner .
7. Press TIMER . Timer indicator light will flash . Display will show
remaining hours before the air conditioner will turn on .
8. Press the plus or minus TEMP button to change the delay
time from 30 minutes to 24 hours .
9. After 5 seconds , Timer indicator light will remain on . Display
will show the current room temperature .
To clear Timer delay program :
NOTE : Air conditioner can be either on or off .
1. Press TIMER once after it has been programmed . Display will
show remaining time .
2. While the display is showing the remaining time , press TIMER
again . Timer indicator light will turn off .
To see or change the remaining time ( in hours ):
1. Press TIMER once after it has been programmed . Display will
show remaining time .
2. While the display is showing the remaining time , press the
plus or minus TEMP button to increase or decrease the time .
3. After 5 seconds , the display will show the current room
temperature .
To change the temprature dislay from ° F to ° C :
P ress both the plus and minus TEMP buttons at the same
t ime to switch the display from ° F to ° C.