22
AFTER-SALES SERVICE
Before contacting After-Sales Service:
1.
See if you can solve the problem yourself with
the help of the “Troubleshooting guide”).
2.
Switch the appliance on again to see if the
problem has been solved. If it has not,
disconnect the appliance from the power
supply and wait for about an hour before
switching on again.
3.
If the problem persists after this course of
action, contact After-sales Service.
Specify:
•
the nature of the problem
•
the model
•
the Service number (the number after the
word SERVICE on the rating plate on the
inside of the appliance)
•
your full address
•
your telephone number and area code.
INSTALLATION
•
Install the appliance away from heat sources. Installation in a hot
environment, direct exposure to the sun or installation near heat
sources (heaters, radiators, cookers) will increase power
consumption and should therefore be avoided.
•
If this is not possible, the following minimum distances must be
respected:
•
30 cm from coal or paraffin stoves;
•
3 cm from electric and/or gas stoves.
•
Fit the spacers (if supplied) on the rear of the condenser
positioned at the back of the appliance (see figure).
•
To optimize appliance efficiency, leave a 5 cm gap above the
appliance and make sure that adjacent kitchen units are
sufficiently distanced to allow air circulation.
•
Install the appliance in a dry, well-ventilated place, and ensure it
is level, using the front adjustment feet if necessary.
•
Clean the interior.
•
Fit the accessories.
Electrical connection
•
Electrical connections must be made in accordance with local
regulations.
•
Voltage and power consumption are indicated on the rating plate
inside the appliance.
•
Regulations require that the appliance is earthed.
The Manufacturer declines all liabilities for injury to persons or
animals or damage to property resulting from failure to observe
these regulations.
•
If the plug and socket are not of the same type, have the socket
replaced by a qualified electrician.
•
Do not use extension leads or adapters.
Disconnecting the appliance
It must be possible to disconnect the appliance by unplugging it or
by means of a two-pole switch fitted upline of the socket.
60202016.book Page 22 Friday, December 14, 2007 4:30 PM
