27
Heater mode
Additional instructions
6th Sense mode
1.
Press the MODE button and select heater mode.
2.
You can set TIMER ON or TIMER OFF in heating mode.
1.
If you select cooling or dry mode while the appliance is in another mode, the compressor will be delay-protected.
Wait for 3~5 minutes, after which the appliance will run again. Do not press any button during the waiting time,
or the appliance will re-count the protection time.
2.
In Cool or Dry mode the compressor and fan will stop when the room temperature reaches the set temperature.
Pressing the 6th Sense button enables fuzzy logic function with the unit either on or off. In this mode, temperature and
fan speed are set automatically depending on the actual room temperature.
Pressing the FAN button in 6th Sense mode when the appliance is in cooling mode will change fan speed in the following
sequence: Auto - High - Low. In dry mode, the LCD display will appear as shown in the figure on the right although only
Auto-speed will be enabled.
Operation mode and temperature are determined by indoor temperature
Indoor temperature
Operation
mode
Target temperature
23°C or below
DRY
Room temperature decreases 1.5°C after
operating for 3 minutes
Over 23
COOLING
23°C
Important: 6th Sense button is ineffective in JET mode.
Note: Temperature, airflow and direction are controlled automatically in 6th Sense mode. However, a
decrease or increase of up to 2°C can be set with the remote control or control panel if you still feel
uncomfortable.
A decrease or increase of up to 2°C can be set in 6th Sense mode
Your feeling
Button
Adjustment procedure
Slightly warmer
A decrease up to 2°C can be set
Press once to lower the set temp by 1°C
Press twice to lower the set temp by 2°C
Slightly cooler
A rise up to 2°C can be set
Press once to raise the set temp by 1°C
Press twice to raise the set temp by 2°C
Uncomfortable because of unsuitable air flow
volume.
Indoor fan speed switches from High to Low
each time the button is pressed.
Uncomfortable because of unsuitable flow
direction.
Press once to alter the position of the vertical
louver and change the direction of airflow.
Note: There is no swing button on the
control panel. Pressing the FAN button for
3 seconds will enable the swing function on
the control panel. Press the FAN button
again for 3 seconds to cancel this function.
