5
INSTALLATION
Technical information for the installer
Unpack the oven to make the connections.
Rest the oven on the polystyrene base to avoid damaging it.
Do not lift the oven by the door handle, but hold it at the sides.
Make sure that the appliance has not been damaged during transport.
The dimensions of the oven and the unit are given in the picture below.
Units in contact with the oven must be heat resistant (90°C).
If plastic laminates or the sealing material are not sufficiently heat resistant, bubbles may
form, the surface may be deformed or the coating may detach.
House the oven in the unit cavity, lifting it at the sides and making sure that the supply
cable is not trapped.
To ensure correct ventilation, respect the ventilation openings indicated in the picture
(200 mm
2
minimum).
Fasten the oven to the unit with the screws
(
A
) as shown.
The oven can also be fitted under a cooktop.
A
A
A
A
There must be a gap of at least 5 mm between the upper edge of the oven and the lower
edge of the working surface. This gap must never be closed by strips or unit reinforcing
pieces. When the oven is installed, make sure that the sides do not touch the front edges
of the unit or the adjacent drawers and door (see below picture).
No Contacts
3gb66002a.fm5 Page 5 Wednesday, April 3, 2002 2:32 PM
