background image

PRECAUTIONS AND GENERAL RECOMMENDATIONS

To ensure best use of your hob, please read these instructions carefully and keep them for future reference

These instructions are only valid for those Countries where the destination abbreviations are mentioned on the 

product description sheet and on the hob.

Keep the packing elements (plastic bags, polyurethane foam, etc.) out of the reach of children, as they are a potential 

source of danger.

Check whether the hob has been damaged during transport and remove any protective film from the appliance 

parts.

This hob (Class 3) is designed solely for household use for cooking food. Any other use (such as heating 
rooms) is to be considered improper and, as a consequence, dangerous.

Make sure the installation and gas/electrical connections are carried out by a qualified technician in 
compliance with the current local regulations.

This appliance should only be installed and used in well-ventilated rooms, in accordance with current 
regulations. Carefully read the instructions before installing and using this appliance.

Gas adjustment and supply pressure are indicated on the rating plate located under the hob. If the appliance 
is arranged for a type of gas different from that available, refer to the paragraph “Ajustment to different 
types of gas”.

RELEVANT NATIONAL REGULATIONS

Ensure that the installation and gas connections are performed by a qualified technician, following the manufacturer's 
instructions and in compliance with current local safety regulations.

SAFEGUARDING THE ENVIRONMENT

1. Packaging 

The packaging material is entirely recyclable, and is marked with the recycling symbol 

, which identifies it as a type 

of material that must be sent to local waste-disposal centres.

2. Product 

This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic 
Equipment (WEEE).
By ensuring that this appliance is scrapped suitably, you can help prevent potentially damaging consequences for the 
environment and health. 

The symbol 

 on the product, or on the documents accompanying the product, indicates that this appliance may 

not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling 
of electrical and electronic equipment. 
Disposal must be carried out in accordance with local environmental regulations for waste disposal.
For further information on the treatment, recovery and recycling of this product, contact the competent local 
authority, the domestic waste collection service or the shop where you purchased the appliance.

Declaration of conformity

This hob has been designed, constructed and marketed in compliance with:

-

safety requirements of “Gas” Directive 2009/142/EC (ex: EEC 90/396);

-

safety objectives of the “Low Voltage” Directive 2006/95/EC (which replaces 73/23/EEC and subsequent 
amendments);

-

protection requirements of EEC “EMC” Directive 2004/108/EC;

This hob is suitable for contact with foodstuffs and complies with EEC (CE) Regulation n. 1935/2004.

NOTES

:

Improper use of the grids could scratch the hob. Do not position the grids upside down or drag them across the hob.

If the hob has a glass ceramic top, do not use:
-

Cast iron griddles or terracotta pots and pans

-

Heat diffusers (e.g. metallic mesh)

-

Two cookers for the same pot

In case of prolonged use, additional ventilation may be needed (opening a window or increasing the extraction 
force of the hood).

The appliance is not intended for use by people (children included) with physical, sensory or mental impairment or 
without experience and knowledge of the appliance, unless supervised or previously instructed in its use by those 
responsible for their safety.

Keep children away from the hob when it is in use and do not let them play with the controls or any other appliance.

Warning

: the protective rubber feet on the grids represent a choking hazard for young children. After removing the 

grids, please ensure that all the feet are correctly fitted.

Attention

: The glass lid (if provided) may shatter if overheated. Before closing it, be sure that all burners are off.

After use, make sure that the knobs are in position OFF and close the main gas delivery or cylinder tap 

INSTALLATION

 

TECHNICAL INFORMATION FOR THE INSTALLER

This product can be embedded in a worktop 20 to 40 mm thick. 

If there is no oven beneath the hob, insert a separator panel that has a surface at least equal to the opening in 

the work surface. This panel must be positioned at a maximum distance of 150 mm below the upper surface 
of the work surface but, in no case less than 20 mm from the bottom of the hob. If there is an oven beneath 
the hob, make sure that it is manufactured by Whirlpool and equipped with a cooling system. The 
manufacturer declines all liability if another brand oven is installed beneath the hob.

Before installation, make sure that:

-

the local gas delivery conditions (type and pressure) are compatible with the settings of the hob (see the 

rating plate and injector table).

-

The outer surfaces of the furniture or appliances adjacent to the hob are heat resistant according to local regulations.

-

Combustion products are discharged outdoors through specific hoods or wall and/or window mounted electrical 

fans.

Summary of Contents for AKT 780

Page 1: ...ble panstand grids 2 Auxiliary burner 3 Semirapid burner 4 Rapid burner 5 Semirapid burner 6 4 ring burner 7 Auxiliary burner control knob 8 Semirapid burner control knob 9 Rapid burner control knob 10 Semirapid burner control knob 11 4 ring burner SYMBOLS Tap closed Maximum flame Minimum flame Burner Pot Ø 4 ring from 24 to 26 cm Rapid from 24 to 26 cm Semirapid from 16 to 22 cm Auxiliary from 8 ...

Page 2: ... waste collection service or the shop where you purchased the appliance Declaration of conformity This hob has been designed constructed and marketed in compliance with safety requirements of Gas Directive 2009 142 EC ex EEC 90 396 safety objectives of the Low Voltage Directive 2006 95 EC which replaces 73 23 EEC and subsequent amendments protection requirements of EEC EMC Directive 2004 108 EC Th...

Page 3: ...lified electrician ASSEMBLY After having cleaned the perimeter surface apply the supplied gasket to the hob as shown in the figure Earth yellow L N Position the hob in the worktop opening made respecting the dimensions indicated in the Product Description Sheet Note the power supply cable must be long enough to allow the hob to be removed upwards from the worktop To secure the hob use the brackets...

Page 4: ...d with the burner and that the burner feet are fitted in the respective housings on the hob surface In the case of single grids make sure that they fit on the burner cap protuberance Models equipped with electrical ignition plugs and safety device require thorough cleaning of the plug end in order to ensure correct operation Check these items frequently and if necessary clean them with a damp clot...

Reviews: