N
C
M
Y
INSTALLATION
FASTENING THE COOKTOP
Each cooktop is supplied with a set of tabs and screws
to fasten it on units.
− Cut the unit (as shown in the figure on the previous
page).
− Stretch gasket “D” over the edge of the hole made,
being careful to overlay the junction edges.
− Turn the cooktop over and put tabs “A” into the
mountings; only tighten screws “B” a few turns.
Make sure that the tabs are mounted correctly as
shown in the figures at the side. Turn the tabs so
that the cooktop can be put into the hole.
− Put the cooktop into the hole cut into the unit and
position it correctly.
− Put tabs “A” into place; tooth “C” of the tabs should
go into the hole.
− Tighten screws “B” until the cooktop is completely
secured.
− Using a sharp tool cut off the part of gasket “D”
which protrudes from the cooktop.
AKR 024 – AKR 010 – AKR 012
20 mm min.
40 mm max.
A
B
C
D
AKR 028 – AKR 011 – AKR 014
30 mm min.
40 mm max.
B
A
C
D
A
A
A
A
38
38
