13
11 PROBLEMS AND ANOMALIES (USER)
PROBLEM
POSSIBLE CAUSE
POSSIBLE REMEDY
THE LED POWER INDICATOR
DOES NOT TURN ON
There is no electrical current
Verify the electrical current connection.
THE WASH PROGRAM DOES
NOT START
The dishwasher has not finished
loading
Wait for the
led indicator to
turn on
Sprinkler wash holes are clogged
or encrusted
Disassemble and clean the sprinklers
(10.2 Periodic checks)
Detergent or rinse-aid insufficient
or not adequate
Verify detergent type and quantity.
Plates / glasses poorly positioned
Arrange plates / glasses accordingly.
Low wash temperature
Verify the temperature shown on the
display, if below 50°C call Assistance.
POOR WASHING RESULTS
Inadequate cycle setting
Increase the duration of the wash
cycle, particularly if dishes are very
dirty or contain partially dried residues.
RINSE INSUFFICIENT
Sprinkler nozzles clogged
Calcium encrustations in the
boiler
Verify the cleanliness of the nozzles
and the correct function of any
installed water softeners.
GLASSES AND SILVERWARE
ARE STAINED
Rinse-aid inadequate or not
dispensed correctly.
Water is of a hardness level
above 12°dF or contains many
dissolved salts
Verify the rinse-aid container and
ensure its adequacy for use with the
water supply. If the problem persists
contact assistance.
WATER IS PRESENT IN THE
TANK AFTER DRAINING
Drainage tube is positioned poorly
or is partially blocked
Verify that the dishwasher’s tube and
drain are not blocked and that the
drain is not in too high of a position;
see the connection diagram.
12 SCREEN DISPLAYED ANOMALIES (USER)
After having turned the machine off and on again, if the problem persists communicate the type of error displayed
on the screen to technical assistance:
E1
Boiler sensor malfunction
E2
Tank sensor malfunction
E3
Water loading timeout ( the water loading duration has exceeded the time set in P9 )
E6
Draining anomaly. At the end of the draining phase the CPU still detects water in the Tank. This may be
due to: Drain pump malfunction, Drain tube blockage, Tank Pressostat malfunction, Drain cycle time set
too low
E7
30 minute Tank timeout
E8
15 minute boiler timeout
