10
8.3 FIRST DAILY USE (Tank and boiler empty)
Activate the wall switch. Two small illuminated points on the display will turn on; the led indicator on the left of the
switch
will be lit red in order to indicate that the machine is receiving electrical current; Position the
overflow and close the hood.
-
Press the general power
button. The led indicator to the right of the button
turns green
and the machine begins to fill itself. The
led indicator will begin to flash. Once filling has been
completed it will stop flashing and will remain a steady green
-
Select the desired washing time by means of the
selectors, keeping in mind
that upon first use the machine is positioned automatically on a medium cycle
. The green led
indicator relative to the selected cycle turns on. The led indicator flashes until the end of the wash cycle,
after which it turns a steady green again. To start the cycle, open the hood, insert the basket and close the
hood; the selected led indicator will begin to flash and will stop flashing at the end of the completed cycle.
-
The display will indicate the wash or rinse temperatures based upon the active function of the machine.
Note: if the machine came equipped with rinse delay, the wash will continue until the programmed rinse
temperature is reached, after which the cycle will terminate. After having selected the continuous cycle
,
the led indicator
will start to flash. To interrupt the cycle press
again. The rinse will begin and
the cycle will terminate once the led indicator
becomes a steady green.When finished, for models with a
drain pump, remove the overflow and press
for 4 seconds. Drainage will begin once the led indicator
turns on, and will terminate with the automatic shutdown of the machine.
9
PROGRAM SELECTION
PROGRAM WASH
TYPEOLOGY
DURATION
(*)
Glasses
Brief about 1’ 15”
Glasses, cups, very dirty plates
Medium about 2’
Silverware and very dirty plates
Long about 3’
Particularly dirty dishes
Continuous from 0 to 10’
(*)The cycle durations indicated above are based upon a tri-phase connection with a 50°C hot water
supply.
Where a cold water supply is used, the duration of the cycle could increase in relation to the input water
temperature.
