16
•
Unpack the appliance and ensure that the
various elements (plastic bags, polystyrene
pieces, etc.) are well out of the reach of
children.
•
Remove the 4 protection pieces inserted
between lid and appliance (A).
•
Important: place two of the four
protection pieces (A), used to protect the
lid during transport, in the capacitor
plastic holder recess on the rear of the
appliance (E).
This operation is necessary in order to
ensure the proper distance of the appliance
from the wall.
•
Remove the packaging from the bottom
(B) of the freezer.
•
After connecting the appliance to the
mains, when the right temperature has
been reached (about an hour), ensure that
the fast freeze function is inactive (yellow
LED is off).
•
During the freezing phase, the lid does
not open until the right temperature has
been reached (about 1 hour).
•
Ensure that the defrosting water drainage
plug is correctly positioned (C).
•
Ensure that the lid seal is not damaged: to
remove any deformation, warm the seal with
a hair dryer.
•
Before connecting the appliance to the mains
supply, ensure that the voltage corresponds
to that given on the rating plate (see figure
below).
•
After the freezer has been installed, check
that it is not resting on the mains cable.
•
Install the appliance in a dry, well ventilated
room. Avoid locations near a source of heat
or in direct sunlight.
•
For optimum appliance operation and in
order to avoid damage when the lid is
opened, leave a space of at least 7 cm from
the rear wall and 7 cm at the sides.
•
Fit the accessories.
ELECTRICAL CONNECTION
•
Electrical connections must be made in
accordance with local regulations.
•
Data regarding voltage and absorbed power
are given on the rating plate on the rear of the
appliance (D).
•
Regulations require that the appliance is
earthed. The manufacturer declines all
liability for injury to persons or animals
and for damage to property resulting from
failure to observe the above procedures
and reminders.
•
If the plug and socket are not of the same
type, have the socket replaced by a qualified
electrician.
•
Do not use extension leads or adaptors.
DISCONNECTING THE APPLIANCE
•
Electrical disconnection must be possible
either by unplugging the appliance or by
means of a double-pole switch located upline
from the socket.
INSTALLATION
70 mm
70 mm
70 mm
C
B
A
42000BGB.fm5 Page 16 Tuesday, December 21, 1999 3:41 PM
