8
■
When the Hour indicator light is lit, the display shows the time
remaining on the Timer setting. See “Timer Delay.”
1. Remove clear protective film from control panel and front
panel badge.
2. Press POWER to turn on air conditioner.
NOTE: When air conditioner is turned on for the first time
after it is plugged in, it will display the default settings: Cool
mode, Turbo fan speed, 72°F (22°C) for 3 seconds. When it is
turned on at all other times, it will display the previous
settings for 3 seconds, and then display the room
temperature.
3. Select mode. See “Mode.”
4. Select fan speed. See “Fan Speed.”
5. Set temperature. See “Temperature.”
Mode
1. Press MODE until you see the indicator light come on for the
setting you desire.
2. Choose Auto, Cool, Fan Only or Power Saver.
■
Auto—Cools room while it automatically controls fan
speed. You cannot change fan speed, but you can adjust
temperature by pressing the plus or minus button.
■
Cool—Cools room. You can select fan speed by pressing
FAN SPEED. You can then adjust temperature by
pressing the plus or minus button.
■
Fan Only—Only the fan runs. You can select the fan
speed by pressing FAN SPEED, but you cannot adjust the
Temperature control setting. Display shows the current
room temperature.
■
Power Saver—You can select the fan speed by pressing
FAN SPEED. Fan runs only when cooling is needed. Fan
stops running when the room temperature matches the
Temperature control setting.
Because the fan does not circulate the room air
continuously, less energy is used, but the room air is not
circulated as often. Use Power Saver when you are
asleep or away from home.
Fan Speed
NOTE: The Fan Speed button will operate only when Cool, Fan
Only or Power Saver mode has been selected.
1. Press FAN SPEED until you see the indicator light come on
for the setting you desire.
2. Choose Turbo, High or Low.
Filter Reset
1. When Filter indicator light is lit, remove, clean and replace air
filter. See “Cleaning the Air Filter.”
2. Press and hold FILTER for 3 seconds after replacing the air
filter.
NOTE: After 360 hours of fan operating time, the Filter indicator
light will turn on. It will remain on for 180 hours or until you press
FILTER. After 180 hours, it will flash.
Temperature
■
Press the plus button to raise the temperature. Room
indicator light will turn off, and Set indicator light will turn on.
Display shows the Temperature control setting. Each time you
press or hold the plus button, the temperature will go up
1º until it reaches 86°F (30°C).
NOTE: After 3 seconds, Set indicator light will turn off, and
Room indicator light will turn on. Display will show the current
room temperature.
■
Press the minus button to lower the temperature. Room
indicator light will turn off, and Set indicator light will turn on.
Display shows the Temperature control setting. Each time you
press or hold the minus button, the temperature will go down
1º until it reaches 64°F (18°C).
NOTE: After 3 seconds, Set indicator light will turn off, and
Room indicator light will turn on. Display will show the current
room temperature.
To change the temperature display from °F to °C:
1. Turn off the air conditioner.
2. While the air conditioner is off, press and hold down the
MODE and FAN SPEED buttons while pressing POWER to
turn on the air conditioner.
NOTE: Follow these same steps to change the temperature
display from °C to °F.
Timer delay
To set the Timer for a 1- to 24-hour delay until the air
conditioner turns off (the air conditioner must be On):
1. Press TIMER. Timer indicator light will flash. Hour indicator
light will turn on, and display will show remaining hours
before air conditioner will turn off.
Summary of Contents for ACQ088MS
Page 14: ...14 Notes ...
